Prep - AquaKlean
Prep - RustBlast
Rust Sealer
Primers
Tank Sealer
Kits
Epoxy Putty
Spray Guns
Thinners
Supplies
Howie's How To Section
3 Step System
AquaKlean Info Page
RustBlast Info Page
RustSeal Info Page
RustSeal Tech Data Sheet
Tank Sealer Info Page

Join our mailing list!



KBS 3 STEP SYSTEM

KBS Coatings products are designed to work as a COMPLETE SYSTEM. When used together, these products provide you with a coating that will not only stop rust, but will protect it from returning.

To aid you in your particular rusty metal project, we have included the following steps to explain the various stages in rust prevention.

All KBS Coatings products are available individually or many are available in efficient, cost-saving kits geared to your specific restoration need.  Check out the kits HERE.
Before KBS Coatings

AquaKlean
STEP #1 - AQUAKLEAN

AquaKlean should always be diluted with water. For general purpose cleaning, apply liberally and wash surface for 5-10 minutes. For heavy-duty cleaning, extended soaking times up to 24 hours or more may be necessary. Use a bristle brush or scouring pad to expedite the cleaning of heavily soiled surfaces. Retreat surface as necessary until clean.

Do not allow AquaKlean to dry before rinsing. Rinse thoroughly with water after cleaning and let dry.

Complete AquaKlean Application Info HERE >>


KBS RustBlast
STEP #2 - RUSTBLAST

Liberally apply RustBlast FULL-STRENGTH to a DRY surface using a spray bottle, brush, roller, or backpack sprayer for larger applications.

Re-apply often and as needed to keep the surface wet for a minimum of 10 minutes for smooth or lightly rusted surfaces, 20-40 minutes for moderately rusted surfaces and 1-2 hours for  heavily rusted or corroded surfaces. DO NOT allow surface to dry.

After treatment, rinse thoroughly with water and then allow surface to dry completely.

Complete RustBlast Application Info HERE >>


KBS RustSeal
STEP #3 - RUSTSEAL

Apply RustSeal to prepared surfaces by brush, roller, or spray equipment. Brush marks will level out as if sprayed.

Always apply a MINIMUM of 2 full coats (2 mils each) for general applications. For marine or industrial applications, apply a minimum of 3 full coats (3 mils each). Recoating can be done once the first or consecutive coat is dry-to-touch.

Complete RustSeal Application Info HERE >>


KBS Coatings

 About Us
 Become an Affiliate
 Privacy Policy
 Send Us Feedback